The full race 16v twincam engine is a awsome conversion designed for massive top end power, it has been developed for competing against 7-port, 8-port and the famous KAD engines now being used in many events were anything go's. This engine spec has given race driver Rohith de Silva many 1st place finishes and class wins. With the correct set up we have seen 178 BHP. this engine can be used with the traditional weber carbs and distributor or throttle bodys with full engine management.

Welcome to Morspeed performance tuning

 16v twincam engine

1293-1480cc 16v TWINCAM STEEL RACE ENGINE

CYLINDER BLOCK: The block is fully prepared to accept the twincam cylinder head, chemically dipped, Off-set bored and plateau honed to a finish size, the cylinder block main caps are replaced for a 4-bolt all steel set then linebored, the block internals are stress relived and 5/16 large sump fixings are used, the block is re-surfaced to ensure a perfect head gasket seal, Then fitted with new VP2 lead copper jackshaft bearings. All threads are checked and re-tapped then after a three stage final build clean the block is painted and fitted with new oilways & core plugs.

CRANKSHAFT: The crankshaft is a steel unit which comes in a stroke of your choice & dynamic balanced, then a final micro polish to the journals is applied. fitted with new competition lead copper bearings.

CONRODS: Conrods are steel 'H' section fitted with new ARP bolts and nuts. A full end to end balance is performed.

PISTONS: A set of 16v pocketed Omega pistons are fitted.

JACKSHAFT: A jackshaft is fitted to drive the high capacity steel backed oil pump along with cam belt drive gears. A modified trigger damper is also used if DTA is required.

GEARBOX: The gearbox is completely stripped to a bare casing, and chemically dipped removing all traces of internal oil staining and external paint. The gearbox is then fully prepared ensuring all gasket surfaces are flat and all threads are good. The gearbox is then built with a Swiftshift clutchless dog gear set, S/cut roller drop gears. new double roller bearing, single roller bearing, needle roller bearings, high grade central oil pick up pipe, ATB LSD diff unit and final drive. (the final drive ratio will be decided on application).

Transfer gears are reshimmed on the idler and primary to the correct tolerence with new input spigot bearing.

CYLINDER HEAD: Full race cylinder head is fitted which is fully gasflowed polished and fully port bored by approx 3mm to accept a pair of weber 45DCOE's or throttle bodys, using STD size back cut valves and 3 angle valve seats to gain maximum air flow. Silicon bronze valve guides with full tapers to also aid air flow. Combustion chambers are then balanced. The head gasket face is then machined to achive the desired compression. On the final stage all the valves are hand lapped and seat pressure is tested and it is cleaned and assembled using the required valve springs, MSPD full race camshafts, tappets are set, alloy vernier timing gears, performance cam belt & tensioner.

ANCILLERIES: Also included is the option of ancilleries below:

1) A pair of 40DCOE weber carbs with filters & 1" alloy manifold, Custom dizzy with high compression leads & spark plugs, 4-2-1 Maniflow Ex manifold.

2) A set of throttle bodys with filters, DTA self programing ECU & custom wire loom, high compression leads & spark plugs, 4-2-1 Maniflow Ex manifold.

The finished unit is painted in a choice of  red, blue, black or BMC green and assembled using plated external nut and bolts.

 Test bed run for approx 2 hours with a full diagnostic report. A full dyno session can be added for an extra £450

Fully assembled twincam sprint engine 1293-1380cc  £11,800 exch

Please add £600 for an outright sale